Bentel Omnia 4 Especificaciones descargar pdf (Pagina 90)

If is pressed at step 3 ----programming will be quitted. If is

pressed after step 3 ----the current parameter will not be saved and the

control panel will step back to PHASE 1 step 3.

PRESS THE ENTER KEY TO SAVE THE ENTERED PARAMETER

VALUE.

Example D For parameter 1 (keypads in configuration): the accepted keys (1 through

8), and a brief description can be found at the top of the KEYPAD table.

The symbol u at the end of the row indicates that the parameter can be

programmed in the Single mode only.

For parameter 131 (Call Type for telephone number 2): the accepted keys

(0 through 9), and a brief description can be found at the top of the TELE-

PHONE table. The symbol î at the end of the row in the programming ta-

bles indicates that the parameter can be programmed in both Single

mode and Consecutive mode.

For parameter 290 (Clock): data entry instructions can be found at the top

of the CLOCK table. The symbol v between the "day - month - year" and

also "hour and minutes" fields, indicates that the parameter has two fields.

90 Security System Control panels Omnia8/Omnia4

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 90