Bentel Omnia 4 Especificaciones descargar pdf (Pagina 75)

Connection of control panel to PC and Modem to PC

Control panel

PC connection

The programmed parameters must be downloaded onto the memory of the

corresponding control panel. Therefore, it is necessary to make a serial

connection between the PC and the connector 7 of the control panel.

Use a CVSER/9F9F serial cable (not supplied), or make the cable as per

the following diagram.

If the PC serial ports have 25 pole connectors, use an ADSER/9M25F

adapter (not supplied), or make the cable as per the following diagram.

The Main unit must be open during programming, therefore, only author-

ized personnel can access the programming phase. The User must enable

the Teleservice option, otherwise, the control panel will be unable to an-

swer incoming Teleservice calls (refer to "Enable/Disable Teleservice"

paragraph in the USER MANUAL).

Specify the PC serial port used for the connection with the Control panel in

the Serial port settings window (refer to "Serial Ports" paragraph).

Figure 40

PROGRAMMING FROM PC 75

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 75