Bentel Omnia 4 Especificaciones descargar pdf (Pagina 66)

Select Language

To change the language in any of the Omnia4/8 NormaCom2 suite

programs:

Select Language from the Options menu or select the Language button

(depending on the program).

Use the Translat program if the required language is not provided.

Omnia 4-8 NormaCom2 program

This program will store the programmed parameters on the database on

the PC hard disk (Customer file). The data can be loaded, changed, and

sent to control panels of the same type. The OmniaMOD-V1 modem can

be used for Teleservice (i.e. programming and control of the system via

telephone).

The control panel parameter programming pages will be shown on startup.

These pages, and the entire programming procedure, can be found in the

"PROGRAMMING" chapter.

File menu

This menu contains the options for customer management as follows.

New customer If this option is selected, and the data of the previous customer has not

been saved, the program will show the message <<Configuration Not

Saved. Save ?>> YES or NO.

Ø YES saves the data of the previous customer, and opens the New cus-

tomer page with default values.

Ø NO cancels the last changes of the previous customer, and opens the New

customer page with default values.

Open Customer This option opens the Customer database window as shown in figure 36

(list of current customers).

Figure 36 Customer

66 Security System Control Panels Omnia8/4

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 66