Bentel Omnia 4 Especificaciones descargar pdf (Pagina 49)

Code PIN programming

Each Code Type must be programmed with a PIN (Personal Identification

Number). When the Code PIN is entered on a keypad it will identify the User,

and will allow access to the programmed options of the Code in question.

PIN programming via PC requires connection with the control panel (via

serial or modem).

To program Code PINs:

1. Select the PIN button on the Codes page.

2. Select the Load button ----the program will load the Code attributes (De-

scription, Type and Partitions).

3. Enter the PIN of a Main User Code in the Main User Code field then se-

lect OK.

4. Select the Codes to be changed (from the Code table). It is possible to

change the entered PIN, and the User Code PINs (not Main User Codes)

enabled on the partitions it controls.

5. Enter the New PIN in the New PIN field in the PIN Programming section.

6. Enter the New PIN in the Confirm PIN field then select OK.

7. Repeat the procedure as required. Select the Send button to download the

programming to the connected control panel.

Figure 27 Codes page

PROGRAMMING 49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 49