Bentel Omnia 4 Especificaciones descargar pdf (Pagina 87)

Programming Modes

There are three parameter programming modes: Single mode, Consecu-

tive mode, Multi-field mode. Refer to examples A, B, C, and D.

Use the parameter Address tables when programming parameters. The ta-

bles show: a brief description; the keys and/ or accepted values of each

parameter. The programming mode is also shown (refer to example D).

Single mode The u symbol shows the parameter can be programmed in Single mode

only.

1. Enter the parameter Address then press .

2. Program the value of the parameter then press .

Refer to example A.

Consecutive

Mode

The î symbol shows the parameter can be programmed in Single mode

and Consecutive mode.

Parameters programmed in consecutive mode (i.e. all the corresponding

parameters of a zone, output or a telephone number) require entry of the

Address of the first parameter only, as follows.

1. Enter the parameter Address then press .

2. Program the parameter value then press .

3. Program the value of the next parameter then press , and so forth.

Refer to example B.

Multi-field Mode The v symbol shows the parameter can be programmed in Multi-field

mode.

Multi-field mode parameters have more than one field (e.g. Clock pa-

rameter). Therefore, it is necessary to press after programming each

field.

1. Enter the parameter Address then press .

2. Program the value of the first field then press .

3. Program the value of the second field then press .

Refer to example C.

PROGRAMMING FROM KEYPAD 87

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 87