Bentel Omnia 4 Especificaciones descargar pdf (Pagina 44)

Outputs

The Main Unit has 2 programmable open-collector outputs of 0.1 A (termi-

nals [O1] and [O2]). All the outputs can be programmed to supply the fol-

lowing signals: Armed partitions, Disarmed partitions, Trouble, Alarm

Memory, Exit Time, Entry Time, Chime, Arming delay, Alarm and Tamper,

Fire GND, Telephone Line Trouble.

Outputs page

The output programming table is as follows.

Output This is the sequential number of the output on the main board.

Description This is the modifiable description of the Output.

Attributes This determines the electrical status on the output in standby status.

Partitions This determines the partitions that will effect the output. Select the required parti-

tions. Double click on the corresponding cell to enable / disable (YES/NO).

The following output parameters can be programmed on the lower part of

the page. The confirmed data entry will be shown in the table on the upper

part of the page.

Attributes

The open-collector outputs can be programmed as either Normally Open

or Normally Closed (see below).

Normally Open Standby status: the output will be open.

Active status: negative will be present on the output.

Normally Closed Standby status: negative will be present on the output.

Active status: the output will be open.

Signals

The Control panel has 2 auxiliary outputs which can be programmed as

follows.

Partitions Armed The output will be activated when one (or more) of its partitions is armed.

Partitions

Disarmed

The output will be activated when one (or more) of its partitions is dis-

armed.

Trouble The output will be activated in the event of Main Unit trouble: fuse trouble;

mains trouble; low battery; communication bus trouble.

Alarm Memory The output will be activated in the event of alarm memory on one, or more

zones of the partition the output is assigned to.

Exit time The output will be activated during the Exit time of the partitions it is as-

signed to.

44 Security System Control Panels Omnia8/4

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 44