Bentel Omnia 4 Especificaciones descargar pdf (Pagina 83)

Alarm / Restoral Event Codes for CONTACT ID

The following table shows the Alarm / Restoral Event Codes for CON-

TACT: the non-modifiable part of the code is shown in brackets.

Trouble warnings

Trouble LED on keypad is ON

Use Superkey to activate the Trouble viewing mode (refer to USER

MANUAL) and identify the type of Trouble. When the type of trouble is

identified see the corresponding trouble warning (as below).

Key ON during Trouble Viewing Mode

Check that fuse 5 is intact. If the fuse has blown find and illiminate the cause

(short-circuit on terminals [+B] or [+]). Replace the fuse (250 V - 3 A).

Key ON during Trouble Viewing Mode

Check the voltage on terminal 11.

Key ON during Trouble Viewing Mode

Check the polarity on the connectors 14.

For inverted polarity ----connect the battery properly and replace fuse 6

(250 V - 8 A).

For low battery ----recharge or replace the battery as required.

Key ON during Trouble Viewing Mode

Check that at least one keypad is connected, and that all the connections

and addresses of the control devices are done properly (refer to "Connec-

tion of the control devices").

Medical Alarms

Medical (1)AA

Pendant Transmitter (1)A1

Fail to Report In (1)A2

Fire Alarms

Fire Alarm (1)1A

Smoke (1)11

Combustion (1)12

Water Flow (1)13

Heat (1)14

Pull Station (1)15

Duct (1)16

Flame (1)17

Near Alarm (1)18

Panic Alarms

Panic (1)2A

Duress (1)21

Silent (1)22

Audible (1)23

Burglar Alarms

Burglary (1)3A

Perimeter (1)31

Interior (1)32

24 Ore (1)33

Entry / Exit (1)34

Day / Night (1)35

Outdoor (1)36

Tamper (1)37

Near alarm (1)38

General Alarms

General Alarm (1)4A

Exp. Module Failure (1)43

Sensor Tamper (1)44

Module Tamper (1)45

24 hour Non-Burglary

24 hour non-burglary (1)5A

Gas detected (1)51

Refrigeration (1)52

Loss of Heat (1)53

Water Leakage (1)54

Foil Break (1)55

Day Trouble (1)56

Low Bottle Gas level (1)57

High temperature (1)58

Low Temperature (1)59

Loss of Air Flow (1)61

APPENDIX 83

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 111 112

Comentarios a estos manuales

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 83

Comentarios a estos manuales