Bentel Omnia 4 Especificaciones descargar pdf (Pagina 36)

Customer data

The Customer’s Address, City, Customer tel. num and Installation de-

scription are for Customer identification purposes only. The essential data ----

Name, Control Panel type, Installation tel. num. and Customer code

should be programmed as per below. The Firmware Release field shows the

Firmware Release selected from the Options menu or downloaded from the

connected control panel (refer to page 74).

Name Enter the Customer’s name in this field.

Control Panel Enter the control panel type (NormaCom2, Omnia8 or Omnia4) in this field.

The corresponding features will be activated automatically in the software

program (e.g. the Zones page will show 4 zones for Omnia4).

Customer code Enter the Customer code in this field. This code will identify the control panel

when it communicates with the OmniaMOD modem (for Teleservice or test call).

Therefore, each control panel must have a different Customer code. Duplicate

codes will be signalled when an attempt to save Customer data is made (the

code and the control panel it is assigned to will be shown in a dialogue box).

The Customer code entered on the Customer data page will be copied

automatically onto the Teleservice page, and vice versa.

Installation

tel. num.

Enter the number of the telephone line the control panel is connected to.

This telephone number will be called by the OmniaMOD modem and can

be different to the Customer tel.num. (i.e. when more than one telephone

line is available).

Accepted digits: 0 through 9, and commas (,). The comma is for a 2 sec-

ond pauses (e.g. between the prefix and the telephone number).

Figure 21 Customer data page

36 Security System Control Panels Omnia8/4

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 36