Bentel Omnia 4 Especificaciones descargar pdf (Pagina 56)

Events

Program the events in this page. Each event can activate one or both of

the following:

Ø the Digital Communicator (Pulse and DTMF);

Ø the Voice Telephone Dialler.

The events table is set out as follows:

no. This column shows the identifier number of each event.

Description This is a list of the Control panel events (refer to "Programming from key-

pad" for further details).

Telephone

number

The selected telephone numbers (on the right side of the page) will be

called when the corresponding event occurs.

Event code The event codes are usually assigned by the Central Station, and allow the

Central station operators to identify the events.

The 2 digit event codes can comprise digits 0 through 9 and hexadecimal

digits A through F. When Pulse protocols are used, Central Stations will

identify 0 and A in the same way .

The 2 digit event codes will be sent to the telephone numbers assigned to

Telemonitoring only (Central Stations).

Contact ID Select the Contact ID button to assign the codes in column A of the table

on page 106. These codes will be sent to the lowest Identifier number of

the Telemonitoring numbers with Contact ID protocol.

Delete Select the Delete button to delete all the event codes and to clear all the

telephone numbers.

Voice message If Voice Calls are programmed for an event, the selected Voice message

will be sent when the event occurs.

56 Security System Control Panels Omnia8/4

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 56