Bentel Omnia 4 Especificaciones descargar pdf (Pagina 67)

To load customer data:

Double click on the required customer or Highlight the required customer

then select the Open button

Save This option saves the data on the hard disk.

Each customer file must have a different Customer code, otherwise, when

an attempt to save data is made, the program will show the message

<<Already Present Continue?>> YES or NO

Ø YES saves the new data and deletes the customer file that was previously

programmed with the same code.

Ø NO holds the data until a new customer code is assigned.

To assign a valid code:

1. Step back to customer page.

2. Enter a new (valid) code.

3. Select the Save button.

Delete Customer This option opens the Customer database (list of current customers).

To delete a Customer:

1. Select the required customer name.

2. Select the OK button.

Close This option quits the programming session. If changes have been made

but not saved the program will show the message <<Configuration not

saved. Save?>> Yes or No.

Ø YES saves the data then quits the program.

Ø NO cancels the last changes then quits the program.

Print The Print command opens a window for printout of details and parameters

of all the Customers on the database.

To print Customer details:

1. Setup the printer (Print Setup button).

2. Select the Customer List to start printout.

To print Customer parameters:

1. Select the required Customers (Print column).

2. Select the required pages (use check boxes).

3. Setup the printer (Print setup button).

4. Select the Print button to start printout.

PROGRAMMING FROM PC 67

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 67