Bentel Omnia 4 Especificaciones descargar pdf (Pagina 88)

Example A

1. Enter the Installer PIN.

2. Press .

LED L7 will flash slowly to signal access to programming ----PHASE 1

3. Enter a valid Address e.g. Address 1 for Keypads in configuration.

4. Press .

PHASE 2 ----LED L6 ON.

5. Setup the keypads in configuration (accepted keys 1 through 8).

6. Press to save and step back to PHASE 1.

7. Repeat the procedure from step 3 for other parameters.

PHASE 1 active ----press to quit programming.

PHASE 2 active ----press to step back to step 3 then press ESC

again to quit programming.

PRESS THE ENTER KEY TO SAVE THE ENTERED PARAMETER

VALUE.

Example B

1. Enter the Installer PIN.

2. Press .

LED L7 will flash slowly to signal access to programming ----PHASE 1.

3. Enter a valid Address e.g. Address 60 for Partition assignment Zone 1.

4. Press ----PHASE 2 ----LED L6 ON.

5. Assign the partitions for zone 1 (accepted keys 1 through 4).

6. Press to save parameter 60, and step to parameter 61 for Type

Zone 1 (PHASE 2.)

7. Program the Type for zone 1 (accepted keys 1 through 6).

8. Press to save parameter 61 and step to parameter 62 for Balance

type Zone 1 (PHASE 2).

9. Program the Balance type for zone 1 (accepted keys 1 through 4).

88 Security System Control panels Omnia8/Omnia4

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 88