Bentel Omnia 4 Especificaciones descargar pdf (Pagina 73)

The box at the bottom of the Connection management window provides

connection status information, as per the following messages.

Omnia/Norma MODEM v. x.xx Shows the version of the modem

connected to the PC serial port.

Modem not recognized Modem not recognized on the

selected serial port. Check the

cable and the selected serial port in

the Options > Serial ports menu.

Receiving.... The Modem / PC system is waiting

for an incoming call. This is the sys-

tem status when the window opens.

RING The modem is detecting rings on

the telephone line.

BACK RING After the dialling the telephone is

ringing.

NORMA ACK A NormaCom Control Panel ac-

knowledged.

OMNIA ACK An Omnia Control Panel acknowl-

edged.

OMNIA8/4 ACK An Omnia8/4 Control Panel ac-

knowledged.

NORMACOM2 ACK A NormaCom2 Control Panel ac-

knowledged.

Installer Code reading error The Code PIN sent through the

software to the Control Panel

cannot be read, probably due poor

quality telephone line signal.

Failed connection Communication to the Control

Panel cannot be established prob-

ably due to poor quality telephone

line signal.

On-hook This option cuts the OmniaMOD connection to the telephone line. The pro-

gram will request confirmation ("On Hook?"), the "On Hook OK " message

will be shown after several seconds.

Setup modem Opens the OmniaMOD modem parameters window.

Clock: set the modem clock. Communications to the central station will

have the corresponding date and time.

Dial mode: select the dialling mode. If both DTMF and Pulse are available

----select DTMF as it is faster.

PROGRAMMING FROM PC 73

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 73