Bentel Omnia 4 Especificaciones descargar pdf (Pagina 85)

PROGRAMMING FROM KEYPAD

For in-detail information on the following parameters and options refer to the

"PROGRAMMING" chapter.

All the Control panel parameters can be programmed from the Keypad.

Only the INSTALLER PIN and MAIN USER PINs can access the program-

ming phase.

The Control panel will be out of service (alarm output disabled) during the

programming phase.

Restrictions

The Installer can program all the control panel parameters, with the excep-

tion of Code PINs 1 through 23.

The Main User can program Code PINs 1 through 23, but not the Code pa-

rameters (see below).

CODE No. TYPE

ASSIGNED

PARTITIONS

Code1 MAIN USER 1 - 3 - 4

Code2 MAIN USER 2 - 3

Code3 USER 1 - 3

Code4 USER 4

Code5 USER 3 - 4

Code6 PATROL 2

Code7 DURESS 3

Code8 USER 2 - 3

In the example above Code 1 can program and change the PINs of: Code

1, Code 3, Code 4, Code 5 and Code 7.

Code 2 can program and change the PINs of: Code 2, Code 6, Code 7

and Code 8.

Access to programming

The Control panel must be disarmed.

Installer Enter the INSTALLER PIN then press .

Main User

Enter a MAIN USER PIN, press then press .

Access to programming will be signalled by slow flashing on LED 7 and a long

high-tone beep.

PROGRAMMING FROM KEYPAD 85

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 111 112

Sin comentarios

Bentel Omnia 4 Especificaciones Pagina 85